Wood siding treatment is an extremely vial procedure as far as maintaining the appearance and enhancing the durability of your exterior design is concerned.

Painting and staining are the two techniques that are commonly utilized to treat wood siding. Painting is generally considered the harder option even though it should only be done once in 10 years.

It is however known to be a much easier alternative to painting despite its higher frequency of application. This is mainly because of the similarity that exists between the previous coating and the current staining process.

How to Treat Wood Siding

Painting

The following are the steps to follow when looking to properly prepare your wood siding for painting:

 

Power Washing

Power washing in this case refers to the removal of any siding flaws that may have occurred as a result of the collecting together of substances such as loose paint, mildew, grime and mud among many others.

It is usually done so as to enable the new coating to effectively cling onto the wooden surface in question. It should therefore be thoroughly done before the application of any form of paint on the siding.

 

Repair any Spoilt Areas

Any joints that are vulnerable to water should be caulked using either silicone or polyurethane filling before commencing the painting. Vinyl spackling may also be used in which case it must be applied in two even coatings and allowed to dry.

This caulking is generally known to aid in preventing any potential water leaks as well as ensuring the better application of paint. The replacement of any areas in the wooden siding which have been damaged beyond repair should also be done.

It is also important to smoothen any areas which may have been patched as a result of any previous spackling. Any rough areas on the edges can equally be straightened out through this sanding process.

 

Surface Priming

Priming the siding is usually done in order to create a basis through which quality finishing can be obtained. It should thus be done using a primer which not only matches the color of the paint but also is tinted a little lighter than the paint in question.

There sometimes may be need to apply multiple layers of primer coats so as to ensure that the wood is completely saturated and covered. In such cases, each layer of prime paint should be allowed to independently dry before the application of another coating.

 

Actual Paint Application

The actual paint application is perhaps the most vital stage as far as the appearance of your exterior wood siding is concerned. Roller painting is normally recommended when one is doing the painting themselves even though it is quite time-consuming.

This is because faster methods such as spray painting are usually considered to be effective in obtaining an even coating when engaged by painting experts. Brushing is also recommended when looking to paint around door and window openings.

Whichever method one chooses, one should ensure that the paint coating on the sliding is thick enough in order to achieve a long-lasting effect. Previous coatings should however be allowed to dry first before applying subsequent ones.

 

Pros and cons of painting

Painting is generally known to create a thicker layer of coating when compared to staining. Paints also come in a variety of colors which means that they can cover almost everyone’s aesthetic appeal while providing long-term protection.

Timing must however be considered when one decides to go the painting route. This is because it can only be done effectively under relatively warm conditions. It is also advisable to leave painting to professionals even though this might be more expensive when compared to DIY painting.

Staining

The steps to be followed as far as the staining of exterior wood siding is concerned include:

 

Surface Cleaning

Thoroughly clean your exterior siding using a power washer then apply a coating of bleach on it. Clean out the bleach as per the instructions using the pressure washer and then wait for the said surface to completely dry out.

The drying may take a few days but it is well worth the wait when looking to guarantee a long lifespan for the stain.

 

Caulking

Caulking in this case is simply filling in the gaps to prevent any water penetration. This is mostly done on any water or moisture-vulnerable joints.

 

Staining

The stain chosen should ideally match one’s desired appeal. The only way to guarantee this however is through a spot check. Brushing in the stain is usually the preferred method as far as achieving a highly protective and durable seal is concerned.

It is also important to avoid applying the stain under direct sunlight lest any kind of patching begins to occur.

 

Pros and cons of staining

Staining is an easier process to carry out yourself since it does not require a priming step. It can however result in a low-quality siding when done either on moist siding or under direct sunlight.

How to clean wood siding?

Cleaning your wood siding only requires a detergent solution, a soft brush and a hose pipe.

How to clean Wood Siding

Wetting

The first step generally involves wetting the said surface using a hose pipe.

 

Solution Application and Scrubbing

The solution should then be applied before commencing on scrubbing. The scrubbing process should be both firm enough to remove the stain and smooth enough to preserve the siding.

 

Downward Rinsing

Downward rising should then be done using the same hose pipe. It is however important to make sure that you rinse each section before the detergent dries up on the siding.

How to clean wood siding naturally?

A mild vinegar solution is one of the most common ways of naturally cleaning wood siding. This usually involves splashing the solution on the said surface and softly scrubbing it with either a soft brush or sponge. Rinsing should then be done preferably using a hose pipe.

How to prevent damage on wood siding?

A mild vinegar solution is one of the most common ways of naturally cleaning wood siding. This usually involves splashing the solution on the said surface and softly scrubbing it with either a soft brush or sponge. Rinsing should then be done preferably using a hose pipe.

 

Proper Wood Selection

Rotting is the most common cause of damage on wood siding. Choosing rot resistant wood such as cedar is therefore the first step to prevent the damage on your siding.

 

Coating and Treating

Painting, staining and periodic treating of your wood also go a long way in keeping the moisture that causes decay out of your siding.

 

Above Ground Building

Siding should equally be built about 8 feet from the ground in order to keep it moisture free. Clients are also advised not to lean any pressure-causing implements such as ladders on their siding.

How to keep wood siding from rotting?

One can only keep his or her wood siding from rotting by making sure it stays moisture free. The first step to accomplishing this is by choosing either rot resistant or thermally treated wood for your siding.

Effective painting or staining of your wooden planks also go a long way in keeping moisture out of your siding. Siding should also be built above ground and under properly functioning gutters.

Is wood siding hard to maintain?

No, it is not. Wood siding is generally considered easy to maintain as long as it is given regular attention in terms of prompt cleaning and treating. Treating of wood should generally be done between 1-3 times per decade depending on its coating.

DIY vs. Hiring a Pro

Do it Yourself

Pros

DIY painting is generally considered as a cheaper alternative to hiring a professional. DIY painting is also regarded as a suitable option when dealing with relatively small surfaces which do not require too much professional attention.

 

Cons

DIY painting can be extremely time-consuming due to the lack of painting expertise and professional tools. The inadequacy of the needed implements and knowledge can also lead to a compromise in terms of quality.

Hiring a Pro

Pros

Professionals are known to bring a degree of quality that is generally beyond DIY practitioners. This is because of the skill and tools they possess in as far as the task at hand is considered.

https://homegardenguides.com/siding/ is a great tool that quickly matches you with the best siding specialists in your locality. You can get three estimates from local siding professionals in a matter of two minutes. Kindly follow the steps below to enjoy this great service:

  1. Scroll to the top of the page and enter your zip code
  2. Answer questions about your drywall job
  3. Your drywall siding details are forwarded to three local experts who will send you a price estimate for your job with some friendly advice.

These qualifications also enable them to be extremely time-effective as far as the completion of the said task is concerned.

 

Cons

Professional painters can be rather expensive especially where large painting jobs are at hand.

FAQ's

It takes an average of between$1-$3 per square foot to paint wood siding. This normally totals up to between $1500-$4000 to paint a wood siding of 1500 square feet. The variance in this figure is usually caused by factors such as type of wood and number of coats needed.

Wood siding can last for as long as 20 to 40 years depending on the frequency of treatment and maintenance given to it.

Thompsons Water Seal Editor’s Choice is generally considered to be the best wood sealer as far as exterior surfaces are concerned

Wood siding should generally be painted between 1-3 times a decade depending on the prevailing climatic conditions, the kind of wood in question and the quality of the initial painting task.

Repairing wood siding generally costs between $200-$5000 depending on the kind of wood and the degree of damage. Hole filling for example typically costs about $100 per hole.

Timothy Munene
Author: Timothy Munene - Timothy is a freelance writer and an online entrepreneur.